Skip navigation

 

3D Print of Simon Blanc’s ‘No More Wine’ Character I sculpted in ZBrush. The model came is over a million polys, and it’s been decimated to 200k. This is my most ambitious print to date. The big challenge was all the overhangs, and the tentacles wrapping in and out of one another. Next is to make a few changes to the model, print it out bigger, and paint it.

3dprint-comp

Printer: Reprap type

Material: Ultimachine ABS

Extruder Temp: 230c

Bed Temp: 90c

Slicer: Cura with support

Height: 90mm

Print time: 3hrs

One Comment

    • PatStarace
    • Posted October 20, 2014 at 11:42 am
    • Permalink

    Thank you for asking. Here’s what I used to print the Iron Man Child Prosthetic Hand.

    Printer: Bukobot Vanilla V1
    Extruder: Budaschnozzle 2.0c w/ 0.35mm nozzle
    Filament: Makergeek ABS 3mm Red/Gold
    Extruder temp: 230c
    Bed temp: 110c
    Print speed: 40mm sec, I could go much fast, but wanted to play safe.
    Repetier Host was used for short prints.
    Pronterface was used for longer prints using the SD Card.

    Slicer: Cura


One Trackback/Pingback

  1. […] Starace didn’t mention as to which 3D printer he used for his build, based on previous projects, we’re guessing it may have been an SAM3X8E ARM Cortex-M3 based RepRap. (Pat, are we […]

Comments are closed.

Facebook

Twitter